天然膨润土还原吸附Cr（Ⅵ）

以天然膨润土为吸附剂，还原吸附处理含Cr（Ⅵ）模拟废水。实验结果表明：以（NH₄）₂FeSO₄为还原剂吸附效果最佳；在还原剂加入量为理论值的0.8倍、膨润土加入量为6 g/L、吸附时间为30 min、吸附温度为30 ℃、初始Cr（Ⅵ）质量浓度为1 mg/L的条件下，Cr（Ⅵ）去除率可达99.6%，处理后模拟废水中总铬质量浓度低至0.003 mg/L。天然膨润土对Cr（Ⅵ）的还原吸附符合准二级动力学模型及Freundlich等温吸附模型。     

Joint action and lethal levels of toluene, ethylbenzene, and xylene on midge (Chironomus plumosus) larvae

Aquatic ecosystems are vulnerable to the exposure with petrochemicals such as toluene, ethylbenzene, and xylene (o-, m-, and p-xylene) (TEX) and their adverse effects. Considering the widespread use, occurrence, and high toxicity of TEX, the aim of this work was to investigate the differential toxicity of TEX against midge (Chironomus plumosus) larvae and reveal the joint action of binary and ternary mixtures of TEX using the predictive concentration addition model. More importantly, this research can afford the basic toxicity data and scientific reference for the establishment of water quality criteria or benchmark, water pollution control, and aquatic risk assessment. Single and joint toxic effects of TEX on C. plumosus larvae were investigated using a semi-static bioassay, and the type of joint effects of TEX was ascertained. In the single toxicant experiments, the toxicity of the three pollutants could be sequenced as ethylbenzene > xylene > toluene. Specifically, LC_50s of T, E, and X after a 48-h exposure were 64.9, 37.8, and 42.0 mg/L, respectively. In the binary mixture experiments, the interaction between toluene and ethylbenzene, ethylbenzene and xylene, and toluene and xylene was largely in conformity with partial additive or additive effect as determined by isobologram representation and toxic unit models. In the ternary mixture experiments, the interaction was basically dependent on the use of additive index and mixture toxicity index methods. However, the antagonistic and synergistic actions were not significant. Thus, the tertiary mixture interaction could be regarded as additive action. The concentration addition model could successfully predict the joint action of TEX mixtures on C. plumosus larvae. Particularly, the additive action of TEX on C. plumosus larvae can be further recommended to evaluate water quality criteria of TEX.     

膜电解法在线再生酸性蚀刻液及回收铜新技术

采用极化曲线法研究了酸性蚀刻液阴、阳极电化学行为，并构建了离子膜电解反应体系，考察了在线再生酸性蚀刻液及回收铜的效果。结果表明，阳极氧化过程发生浓差极化，存在极限电流密度，Cu＋含量越高，极限电流密度越大；阴极还原分4步反应进行，存在极限电流密度；强化溶液传质可有效提高阴、阳极极限电流密度，有利于避免电解过程中析出氯气和氢气；在线实验表明，通过监控阳极液ORP，可避免析出氯气；分步降低电流电解有利于避免析出氢气，形成致密的金属铜块；在电流为9～24A范围内分4步电解23．5h可再生酸性蚀刻液23．5L，同时电沉积回收510g铜，纯度高达99．98％。阴极电流效率达到95．2％，吨铜电耗3251kWh。电解过程中无氯气和氢气析出，无废液排放，表明膜电解法在线再生酸性蚀刻液具有良好的应用前景。     

微生物燃料电池法测BOD影响因素研究

以双室无介体微生物燃料电池构建了BOD检测系统,研究了阴极流量、有机物浓度(BOD)及阳极流量的变化对系统响应信号(电池电压)的影响,并考察了系统响应信号与BOD浓度的对应关系。结果表明:阴极流量在1.5～5mL/min时,阴极流量变化对响应信号具有显著的影响,且响应信号随阴极流量增大而增大;当阴极流量由5 mL/min增加到10 mL/min时,阴极流量变化对响应信号影响不显著。BOD浓度在10～150 mg/L时,响应信号随底物浓度增加而升高,而BOD浓度大于150 mg/L时,BOD浓度变化对响应信号没有显著影响。当BOD浓度较高时,阳极流量变化对响应信号影响不大,但当BOD浓度较低时,阳极流量变化对响应信号有显著影响,且响应信号随阳极流量增大而增加。电池稳态电压与BOD浓度在10～150 mg/L范围内成指数衰减关系,而电池电压的初始变化速率与BOD浓度在50～200 mg/L范围有线性响应。     

陶瓷印花废水处理的混凝剂及工艺条件

采用混凝剂聚合氯化铝（PAC）、聚丙烯酰胺（PAM）、聚合硫酸铁（PFS）对陶瓷印花废水进行混凝沉降处理，监测水样的吸光度、浊度、悬浮物，以脱色率、浊度去除率、悬浮物去除率评价混凝处理的效果。结果表明：PAC是陶瓷印花废水沉降处理的理想混凝剂；水样的吸光度、浊度、悬浮物随混凝剂用量增大和沉降时间延长而呈降低趋势，而脱色率、浊度去除率、悬浮物去除率随混凝剂和沉降时间的增大呈增大的趋势；PAC投加量为20mg／L，沉降时间约为24h，水样脱色率达到90．0％，而当PAC投加量达到100mg／L，沉降时间约为4h，陶瓷印花水的脱色率可达到96．0％。证明了药剂用量的增加与沉降时间的延长对混凝过程具有增效作用。     

菱镁矿尾矿制备高活性MgO的性能表征

菱镁矿尾矿经预处理后,在一定条件下制备高活性MgO。使用热重-差热分析仪,分析菱镁矿尾矿的分解温度,应用X射线衍射、SEM分析不同煅烧温度、保温时间对MgO晶体结构的影响,并根据Scherrer公式计算MgO晶粒的尺寸。通过电导率仪测定MgO水化电导率,分析不同条件下的MgO活性,探讨煅烧温度、保温时间、颗粒细度与MgO活性之间的关系。结果发现:煅烧温度在1 050℃,保温时间60 min时,菱镁尾矿完全分解,MgO活性最佳;煅烧温度越高,保温时间越长,MgO的活性越差;MgO颗粒细度越小,活性越高。     

铁炭微电解工艺处理采油废水的研究

随着采油废水产生量的逐渐增大以及排放标准的日益严格,寻找一种经济、高效的处理方法显得十分必要。采用铁炭微电解技术对冀东油田采油废水进行了处理。考察了铁屑粒径、pH值、Fe/C质量比和反应时间对COD去除率的影响并设计了正交实验,结果表明,影响微电解工艺的因素主次关系为:pH>Fe/C质量比>反应时间,在最佳条件pH=5,Fe/C质量比为7∶1,反应时间50 min下,原水COD由170 mg/L降至95.6 mg/L,去除率达43.85%,出水满足国家二级排放标准。     

湿法净化黑烟中添加剂对炭黑沉降性能的影响

湿法净化黑烟中炭黑颗粒物的关键在于降低吸收液的表面张力并以高性能絮凝剂使其从溶液中絮凝、沉降以利于分离。选用十六烷基三甲基溴化胺(CTAB)为主要表面活性剂,使之与十二烷基苯磺酸钠(SDBS)和月桂醇聚氧乙烯(9)醚(AEO-9)进行复配实验,研究了复配液的表面张力,再向最低表面张力的复配表面活性剂溶液中投加絮凝剂聚合氯化铝(PAC)和聚丙烯酰胺(PAM),探讨絮凝剂的添加对黑烟颗粒沉降和絮凝的影响.实验结果表明:同时添加表面活性剂CTAB,SDBS和PAC,并使之浓度分别为0.5 mmol/L,0.4 mmol/L和200 mg/L时,炭黑颗粒的沉降效果最好,沉降率高达94%,且絮凝体较大,沉降时间仅为2 min。     

回收与降解聚驱采出水的工艺探讨

含聚污水的处理是困扰石油行业的难题之一。基于聚驱采出水的特点,围绕聚合物的回收利用和降解理论及技术,探讨国内外含聚污水处理技术的研究与应用现状,对比分析现有处理技术存在的问题及适应性,提出采用化学混凝、气浮和水质改性等技术来回收利用PAM(聚丙烯酰胺)的新思路,打破了降解PAM的传统思维,同时分析含聚污水处理与利用技术的可行性与应用前景,有望实现含聚污水的循环利用。     

Management-oriented sensitivity analysis for pesticide transport in watershed-scale water quality modeling using SWAT

The Soil and Water Assessment Tool (SWAT) was calibrated for hydrology conditions in an agricultural watershed of Orestimba Creek, California, and applied to simulate fate and transport of two organophosphate pesticides chlorpyrifos and diazinon. The model showed capability in evaluating pesticide fate and transport processes in agricultural fields and instream network. Management-oriented sensitivity analysis was conducted by applied stochastic SWAT simulations for pesticide distribution. Results of sensitivity analysis identified the governing processes in pesticide outputs as surface runoff, soil erosion, and sedimentation in the study area. By incorporating sensitive parameters in pesticide transport simulation, effects of structural best management practices (BMPs) in improving surface water quality were demonstrated by SWAT modeling. This study also recommends conservation practices designed to reduce field yield and in-stream transport capacity of sediment, such as filter strip, grassed waterway, crop residue management, and tailwater pond to be implemented in the Orestimba Creek watershed.